Choosing and Installing Curtains For Your Bathroom
Choosing a standard shower curtain size is dependent largely on personal preference. Although, there are some fundamental rules that one needs to consider when choosing the right shower curtain dimensions. A standard shower curtain should pay for the entire width of a bathtub tub and yet provide you with some slack to make sure water does not splash anyplace else. Ideally, a standard shower curtain size is judged by how much space you need to fill up the shower stall. In a normal shower stall, the average door clearance for the majority of standard shower curtains will be approximately three to four inches. The standard extra span on a shower curtain is generally stated as twelve inches; however, this dimension typically varies from manufacturer to manufacturer.
Most conventional shower stall curtains are offered in standard sizes that range between six and eight inches wide, in addition to between six and ten inches tall. Most makers list their typical shower curtain lengths in inches although not all do so. The length of your shower curtain is largely dependent on the size of your tub and shower stall. You should first measure the entire duration of your shower stall, including the sides, to get an notion of what your curtain will be, but keep in mind that the standard length of a normal curtain is six inches each side. However, the true measurement will be closer to six and a half inches per side for normal tubs that are wider than tall.
So as to get the right size shower curtain for your bathroom, you first have to measure the entire length of your bathroom with the best ceiling slightly over the ground. This can be done with a measuring tape and a pencil. As soon as you have your measurements, write down your own results. You can now visit a hardware store to get the right size curtain sticks and other fittings. If you are constructing a new bathroom, it is always best to have everything ready before you begin. It's easy to make a mistake when you're putting together a new bathroom and it is easy to get things wrong once you're installing something such as a shower curtain.
Ultimately, as soon as you have obtained all of your curtains, it is time to put them up! To do that you must first attach the valance to both sides of the drapes. If you are using standard shower curtain sizes, you need to attach the standard shower curtain rod to the bottom centre of these curtains. Following that, you need to use a shower curtain rod that is the exact same size as the pole you used to attach the valance to. Finally, you need to use a piece of tape to attach the bottom center of the curtain to the shower floor. These are the fundamental steps of choosing and installing drapes for your bathroom.